Creating And Deleting A Dynamic Aggregate Group; Creating A Dynamic Aggregate Group; Deleting A Dynamic Aggregate Group - Alcatel OmniSwitch 6800 Series Network Configuration Manual

Configuring Dynamic Link Aggregation

Creating and Deleting a Dynamic Aggregate Group

The following subsections describe how to create and delete dynamic aggregate groups with the
linkagg size command.

Creating a Dynamic Aggregate Group

To configure a dynamic aggregate group enter lacp linkagg, followed by the user-configured dynamic
aggregate number (which can be from 0 to 29), size, and the maximum number of links that will belong to
this dynamic aggregate group, which can be 2, 4, or 8. For example, to configure dynamic aggregate group
2 consisting of eight (8) links enter:
-> lacp linkagg 2 size 8
You can create up to 32 link aggregation (both static and dynamic) groups can be configured on a standal-
one switch or a stack consisting of up to eight OmniSwitch 6800 Series switches. In addition, you can also
specify optional parameters shown in the table below. These parameters must be entered after size and the
user-specified number of links.
lacp linkagg size keywords
name
actor system priority
partner system priority
For example, to create a dynamic aggregate group with aggregate number 3 consisting of two ports called
"aggregate1" that is administratively disabled, enter:
-> lacp linkagg 3 size 2 name aggregate1 admin state disable
Note. The optional keywords for this command may be entered in any order as long as they are entered
after size and the user-specified number of links.

Deleting a Dynamic Aggregate Group

To remove a dynamic aggregation group configuration from a switch use the no form of the
size command by entering no lacp linkagg followed by its dynamic aggregate group number.
For example, to delete dynamic aggregate group 2 from a switch's configuration you would enter:
-> no lacp linkagg 2
Note. You cannot delete a dynamic aggregate group if it has any attached ports. To remove attached ports
you must disable the dynamic aggregate group with the
described in "Disabling a Dynamic Aggregate Group" on page
OmniSwitch 6800 Series Network Configuration Guide
admin state enable
admin state disable
actor system id
lacp linkagg admin state
November 2004
Configuring Dynamic Link Aggregate Groups
partner admin key
actor admin key
partner system id
command, which is
11-15.
lacp
lacp linkagg
page 11-11