QoS Ports and Queues
To activate the configuration, enter the qos apply command. For more information about the qos apply
command, see
"Applying the Configuration" on page
For actions that set 802.1p bits, note that a limited set of policy conditions are supported. For information
about which conditions may be used with an 802.1p action, see
and
"Action Combinations" on page
Note. 802.1p mapping may also be set for Layer 3 traffic, which typically has the 802.1p bits set to zero.
Verifying the QoS Port and Queue Configuration
To display information about QoS ports and queues, use the following commands:
show qos port
show qos queue
See the OmniSwitch CLI Reference Guide for more information about the syntax and displays for these
commands.
page 21-22
21-46.
21-7.
Displays information about all QoS ports or a particular port.
Displays information for all QoS queues or only those queues associated
with a particular slot/port.
OmniSwitch 6800 Series Network Configuration Guide
"Condition Combinations" on page 21-6
Configuring QoS
November 2004