Configuring Ports To Join And Removing Ports In A Dynamic Aggregate Group; Configuring Ports To Join A Dynamic Aggregate Group - Alcatel OmniSwitch 6800 Series Network Configuration Manual

Configuring Dynamic Link Aggregate Groups
Configuring Ports to Join and Removing Ports in a Dynamic
Aggregate Group
The following subsections describe how to configure ports with the same administrative key (which allows
them to be aggregated) or to remove them from a dynamic aggregate group with the
key command.

Configuring Ports To Join a Dynamic Aggregate Group

To configure ports with the same administrative key (which allows them to be aggregated) enter lacp agg
followed by the slot number, a slash (/), the port number, actor admin key, and the user-specified actor
administrative key (which can range from 0 to 65535). Ports must be the same speed (i.e., all 10 Mbps, all
100 Mbps, or all 1 Gbps).
For example, to configure ports 1, 2, and 3 in slot 4 with an administrative key of 10 you would enter:
-> lacp agg 4/1 actor admin key 10
-> lacp agg 4/2 actor admin key 10
-> lacp agg 4/3 actor admin key 10
Note. A port may belong to only one aggregate group. In addition, mobile ports cannot be aggregated. See
Chapter 6, "Assigning Ports to VLANs,"
You must execute the lacp agg actor admin key command on all ports in a dynamic aggregate group. If
not, the ports will be unable to join the group.
In addition, you can also specify optional parameters shown in the table below. These keywords must be
entered after actor admin key and the user-specified actor administrative key value.
lacp agg actor admin key
keywords
actor admin state
actor system priority
partner admin system priority
partner admin port priority
Note. The actor admin state and partner admin state keywords have additional parameters, which are
described in "Modifying the Actor Port System Administrative State" on page 11-19
Partner Port System Administrative State" on page
All of the optional keywords listed above for this command may be entered in any order as long as they
appear after the actor admin key keywords and their user-specified value.
For example, to configure actor administrative key of 10, a local system ID (MAC address) of
00:20:da:06:ba:d3, and a local priority of 65535 to slot 4 port 1, enter:
-> lacp agg 4/1 actor admin key 10 actor system id 00:20:da:06:ba:d3 actor
system priority 65535
page 11-12
for more information on mobile ports.
partner admin state
partner admin system id
actor port priority
11-23, respectively.
OmniSwitch 6800 Series Network Configuration Guide
Configuring Dynamic Link Aggregation
lacp agg actor admin
actor system id
partner admin keypartner admin
port
and "Modifying the
November 2004