Policy Action Defaults; Default (Built-In) Policies - Alcatel OmniSwitch 6800 Series Network Configuration Manual

QoS Defaults

Policy Action Defaults

The following are defaults for the
Description
Whether the flow matching the
rule should be accepted or
denied
Note that in the current software release, the deny and drop options produce the same effect that is, the
traffic is silently dropped.
Note. There are no defaults for the

Default (Built-in) Policies

The switch includes some built-in policies, or default policies, for particular traffic types or situations
where traffic does not match any policies. In all cases, the switch accepts the traffic and places it into
default queues.
Other traffic—Any traffic that does not match a policy is accepted or denied based on the global dispo-
•
sition setting on the switch. The global disposition is by default accept. Use the
disposition, qos default routed
change the disposition as described in
Global Default Dispositions" on page
The switch network group—The switch has a default network group, called switch, that includes all IP
•
addresses configured for the switch itself. This default network group may be used in policies. See
"Creating Network Groups" on page 21-35
Policy Port Groups—The switch has built-in policy port groups for each slot. The groups are called
•
Slot01, Slot02, etc. Use the
page 21-10
policy action command:
Keyword
disposition
policy condition command.
disposition, and qos default multicast disposition
"Creating Policy Conditions" on page 21-25
21-12.
for more information about network groups.
show policy port group
OmniSwitch 6800 Series Network Configuration Guide
Default
accept
command to view the built-in groups.
Configuring QoS
qos default bridged
commands to
and "Setting the
November 2004