Configuring The Gmap Hold Time; Displaying Gmap Statistics - Alcatel OmniSwitch 6800 Series Network Configuration Manual

Using Interswitch Protocols

Configuring the GMAP Hold Time

The GMAP hold time specifies the length of time the switch retains information received in GMAP update
packets. By default, the holdtime interval is 4320 minutes (72 hours).
To display the current holdtime interval, enter the following command:
-> show gmap
To change the holdtime interval, use either of these forms of the command with the desired value (any
value between 1 and 65535). Note that use of the time command keyword is optional. For example:
-> gmap hold 500
-> gmap hold time 250

Displaying GMAP Statistics

Use the show gmap
-> show gmap
GMAP is currently enabled,
GMAP Holdtime
GMAP Updatetime Interval (seconds)
GMAP Gaptime
MAC Address
--------------+---------+------+--------------+------------
000502:c07f11
00105a:1873b9
See the OmniSwitch CLI Reference Guide for information about the show gmap command.
OmniSwitch 6800 Series Network Configuration Guide
command to view statistics for all MAC addresses.
Interval (minutes)
Interval (milliseconds) = 133
Protocol VLAN Src Switch ID
1809B 12 0020da:ecc770
800 12 0020da:ecc770
1809B 12 0020da:ecc770
800 12 0020da:ecc770
= 4320,
= 300,
Timeout(sec)
3536
3536
3536
3536
November 2004
Configuring GMAP
page 8-11