How To Define A Mac-Port-Ip Address Binding Rule; How To Define A Mac-Port Binding Rule; How To Define A Port-Protocol Binding Rule - Alcatel OmniSwitch 6800 Series Network Configuration Manual

Configuring VLAN Rule Definitions

How to Define a MAC-Port-IP Address Binding Rule

To define a MAC-port-IP address binding rule, enter vlan followed by an existing VLAN ID then
binding mac-ip-port followed by a valid MAC address, IP address, and a slot/port designation. For
example, the following command defines a MAC-port-IP binding rule for VLAN 255:
-> vlan 255 binding mac-ip-port 00:00:da:59:0c:12 21.0.0.10 2/3
In this example, frames received on mobile port 2/3 must contain a source MAC address of
00:00:da:59:0c:12 and a source IP address of 21.0.0.10 to qualify for dynamic assignment to VLAN 255.
Use the no form of the
that it is only necessary to enter the rule's MAC address parameter value to identify which rule to remove.
-> vlan 255 no binding mac-ip-port 00:00:da:59:0c:12
Note that this binding rule type is also supported on AVLANs. See
cated VLANs," for more information.

How to Define a MAC-Port Binding Rule

To define a MAC-port binding rule, enter vlan followed by an existing VLAN ID then binding mac-port
followed by a valid MAC address and a slot/port designation. For example, the following command
defines a MAC-port binding rule for VLAN 1500:
-> vlan 1500 binding mac-port 00:02:9a:3e:f1:06 6/10
In this example, frames received on mobile port 6/10 must contain a source MAC address of
00:02:9a:3e:f1:06 to qualify for dynamic assignment to VLAN 1500.
Use the no form of the
is only necessary to enter the rule's MAC address parameter value to identify which rule to remove.
-> vlan 1500 no binding mac-port 00:02:9a:3e:f1:06
Note that this binding rule type is also supported on AVLANs. See
cated VLANs," for more information.

How to Define a Port-Protocol Binding Rule

To define a port-protocol binding rule, enter vlan followed by an existing VLAN ID then
binding port-protocol followed by a valid MAC address, a slot/port designation and a protocol type. For
example, the following commands define a port-protocol binding rule for VLAN 1503 and VLAN 1504:
-> vlan 1503 binding port-protocol 3/1 ip-snap
-> vlan 1504 binding port-protocol 4/1 dsapssap F0/F0
The first example command specifies that frames received on mobile port 3/1 must contain an IP SNAP
protocol type to qualify for dynamic assignment to VLAN 1503. The second command specifies that
frames received on mobile port 4/1 must contain a DSAP/SSAP protocol value of F0/F0 to qualify for
dynamic assignment to VLAN 1504.
page 7-14
vlan binding mac-ip-port
vlan binding mac-port command to remove a MAC-port binding rule. Note that it
OmniSwitch 6800 Series Network Configuration Guide
command to remove a MAC-port-IP binding rule. Note
Chapter 18, "Configuring Authenti-
Chapter 18, "Configuring Authenti-
Defining VLAN Rules
November 2004