Configuring Ethernet Ports
As an option, you can document the interface type by entering ethernet, fastethernet, or gigaethernet
before the slot number. For example, to administratively disable port 3 on slot 2 and document the port as
Fast Ethernet:
-> interfaces fastethernet 2/3 admin down
Configuring Flood Rates
The following subsections describe how to enable the maximum flood rate (see
Flood Rate" on page
Flood Rate for Multicast Traffic" on page
(slot), a specific port, or a range of ports (see
Enabling the Maximum Flood Rate
The
interfaces flood
ports, or all ports on a switch (slot).
Note. To enable flood multicasting on an interface, see
Traffic" on page
1-9.
To enable the maximum flood rate on a slot enter interfaces followed by the slot number and flood. For
example, to enable the maximum flood rate on port 3 on slot 2 enter:
-> interfaces 2/3 flood
To enable the maximum flood rate on a single port enter interfaces followed by the slot number, a
slash (/), the port number, and flood. For example, to enable the maximum flood rate on slot 2 enter:
-> interfaces 2 flood
To enable the maximum flood rate on a range of ports port enter interfaces followed by the slot number, a
slash (/), the first port number, a hyphen (-), the last port number, and flood. For example, to enable the
maximum flood rate on ports 3 through 4 on slot 2 enter:
-> interfaces 2/3-4 flood
As an option, you can document the interface type by entering ethernet, fastethernet, or gigaethernet
before the slot number. For example, to enable the maximum flood rate on slot 2 enter and document the
slot as Gigabit Ethernet enter:
-> interfaces gigaethernet 2 flood
Enabling Maximum Flood Rate for Multicast Traffic
The
interfaces flood multicast
fic for a single port, a range of ports, or all ports on a switch (slot).
Note. To enable maximum flood rate on an interface and to disable any flood multicast configuration use
the interface flood command, which is described in
OmniSwitch 6800 Series Network Configuration Guide
1-9), enable the maximum flood rate for multicast traffic (see
1-9), and how to configure the flood rate on an entire switch
"Configuring Flood Rate Values" on page
command can be used to enable the maximum flood rate for a single port, a range of
command can be used to enable the maximum flood rate for multicast traf-
Setting Ethernet Parameters for All Port Types
"Enabling Maximum Flood Rate for Multicast
"Enabling the Maximum Flood Rate" on page
November 2004
"Enabling the Maximum
"Enabling Maximum
1-10).
1-9.
page 1-9