Alcatel OmniSwitch 6800 Series Network Configuration Manual page 425

Configuring QoS
Classify L2 Source:
*No rule matched: (accept)
The display shows Layer 2 or Layer 3 information, depending on what kind of traffic you are attempting
to classify. In this example, the display indicates that the switch found a rule, yuba, to classify destination
traffic with the specified Layer 2 information.
To test a theoretical condition against the set of applied policies, enter the command with the applied
keyword. The switch will display information about the potential traffic and attempt to match it to a policy
(applied policies only). For example:
-> show policy classify l3 applied source ip 143.209.92.131 destination ip
198.60.82.5
Packet headers:
L2:
*Port
*IfType
*MAC
*VLAN
*802.1p
L3/L4:
*IP
*TOS/DSCP
Using applied l3 policies
Classify L3:
*Matches rule 'r1': action a1 (drop)
In this example, the display indicates that the switch found an applied rule, r1, to classify Layer 3 flows
with the specified source and destination addresses.
To activate any policy rules that have not been applied, use the qos apply command. To delete rules that
have not been applied (and any other QoS configuration not already applied), use the qos revert
command. See "Applying the Configuration" on page
OmniSwitch 6800 Series Network Configuration Guide
: 0/0
: any
: 000000:000000
:
: 0
: 143.209.92.131
: 0/0
-> 0/0
-> any
-> 000000:000000
0 -> 0
-> 198.60.82.5
21-46.
November 2004
Creating Policies
page 21-33