Replacing Staple Cartridge (For Booklet Maker Unit For Finisher-B1) - Fuji Xerox ApeosPort-IV C5575 Administration Manual

3
Take the staple cartridge out of the finisher.
Note
4
Pinch both sides of the empty staple case with
your fingers (1), and remove the staple case
from the cartridge (2).
5
Insert the front side of the new staple case into
the staple cartridge (1), and then push the rear
side into the cartridge (2).
6
Push the staple cartridge into the finisher until
it clicks into place.
7
Close the finisher front cover.
Note

Replacing Staple Cartridge (for Booklet Maker Unit for Finisher-B1)

When the optional Booklet Maker Unit for Finisher-B1 is installed and the staple cartridge
needs to be replaced, a message appears on the touch screen. When this message appears,
load a new staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Note
• The staple cartridge is firmly inserted. A slight
force is required to pull the cartridge out of
the finisher.
• If the front cover is not closed completely, a message appears and the machine will remain paused.
Use only staple cartridges recommended by Fuji Xerox.
• To order a staple cartridge, contact our Customer Support Center.
Replacing Consumables
79
3