Clutch Offset Procedure - Polaris 2013 RANGER RZR S Service Manual

CLUTCHING
12. Install drive clutch and torque retaining bolt to
specification.
13. Reinstall drive belt noting direction of belt rotation (see
"DRIVE BELT - Belt Installation"). If a new belt is
installed, install so numbers can be easily read.
14. Replace the outer clutch cover rubber gasket with the
narrow side out.
15. Reinstall outer clutch cover and secure with screws.
Torque screws to specification.
Inner Cover Bolt (Rear): 12 ft-lbs (16.6 Nm)
Outer Cover Bolt: 45-50 in-lbs (5-5.6 Nm)
Driven Clutch Retaining Bolt: 17 ft-lbs (23.5 Nm)
Drive Clutch Retaining Bolt: 40 ft-lbs (54 Nm)
16. Install the clutch cover outlet duct and tighten the
clamps.
17. Reinstall the rear seat base assembly and torque the
mounting bolts to specification.
Mounting Bolts:
40 ft-lbs (54 Nm)
6.8
= T
= T
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.

Clutch Offset Procedure

If the vehicle exhibits drive clutch drag or hard shifting
while at idle speed, a clutch offset adjustment is required.
Washers located behind the driven clutch on the
transmission input shaft may need to be added or
removed in order to obtain the proper offset. Refer to the
"Clutch Offset Procedure" provided below.
1. Follow steps 1-6 of the "PVT Disassembly"
procedure.
Do not start the engine with the outer clutch cover
removed. Serious injury may result.
2. Inspect the drive clutch belt to sheave clearance. If the
belt is contacting either sheave, remove the drive belt
and driven clutch.
Incorrect
Offset
3. Add or remove offset washers behind the driven
clutch accordingly to avoid belt contact with either
drive clutch sheave.
• .030" Offset Washer - PN 7556454
• .060" Offset Washer - PN 7556120
CAUTION
Offset
Washers