Assembly / Removal; Cab Frame (Rzr 4) - Polaris 2013 RANGER RZR S Service Manual

BODY / STEERING / SUSPENSION

CAB FRAME (RZR 4)

Assembly / Removal

NOTE: Finger tighten all components until cab
frame is completely assembled on vehicle, then
tighten to specifications listed.
1. Place rear cab frame and mid cab frame in the
vehicle so they line up with the mounting holes. You
may have to pull the rocker panels out slightly to get
the mid cab frame into place. Assemble at the coupler
joint and secure with (3/8-16 x 1 1/4) bolts and (3/8-
16 Nyloc) nuts. Tighten bolts to specification.
25-28 ft-lbs (34-38 Nm)
2. Fasten rear cab frame brackets to vehicle with (5/16-
18 x 3/4) bolts and (5/16-18 Nyloc) nuts. Tighten bolts
to specification. Fasten a (5/16-18 x 3/4) tap screw to
the rear of the bracket on each side. Tighten tap
screws to specification.
16-18 ft-lbs (22-24 Nm)
Screws:
15 ft-lbs (20 Nm)
3. Insert strap from safety net over front coupler post on
front cab frame. Fasten the front of the cab frame to
the base brackets and mid cab frame using the (3/8-
16 x 1 1/4) bolts and (3/8-16 Nyloc) nuts. Tighten bolts
to 25-28 ft-lbs (34-38 Nm).
25-28 ft-lbs (34-38 Nm)
5.6
= T
Bolts:
= T
Bolts:
= T
= T
Bolts:
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
4. Fasten mid cab frame brackets to the vehicle with (5/
16-18 x 1) bolts and (5/16-18 Nyloc) nuts. Tighten
bolts to specification. Fasten (5/16-18 x 3/4) tap
screws to the outsides of each bracket. Tighten tap
screws to specification.
16-18 ft-lbs (22-24 Nm)
Tap Screws:
15 ft-lbs (20 Nm)
5. Fasten side bars by sliding the lower portion into the
U-shaped bracket on the mid cab frame. Fasten the
upper portion to the rear cab frame using (1/4-20 x 3/
4) Phillips-head screws and (1/4-20 Nyloc) nuts.
Tighten screws to specification. Fasten (1/4-20 x 3/4)
Torx-head screws into lower portion of side bars
through bracket slot. Tighten tap screws to
specification.
Screws:
6-8 ft-lbs (8-11 Nm)
Tap Screws:
6-8 ft-lbs (8-11 Nm)
6. To remove the cab frame, reverse the assembly
procedure (steps 1-5).
= T
Bolts:
= T
= T
= T