Polaris 2013 RANGER RZR S Service Manual page 106

ENGINE / COOLING
25. Install counter balance shaft gear (J) with new key,
aligning timing marks with crankshaft gear (I). Install
washer and bolt. Use the Gear Holder (PU-45838).
Torque to specification.
I
Balance Shaft Gear Bolt:
22  2 ft-lbs (30  3 Nm)
26. Use the Cam Gear Alignment Tool (PU-45497-2) to
align the teeth of the cam gear (M). Install the cam
gear (M) (with the Cam Gear Alignment Tool still in
place) onto the camshaft. The timing marks on the
camshaft gear should align with the keyway on the
balance shaft gear.
PU-45497-2
M
NOTE: If the timing mark on the camshaft gear does
not align properly, remove the camshaft gear and
tool. Use the Cam Spanner Wrench (PU-45498) to
rotate the cam to the proper position.
3.54
J
PU-45838
= T
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
NOTE: Cam Spanner Wrench (PU-45498) is only
needed to rotate the camshaft when the entire valve
train is assembled.
PU-45498
27. Reinstall the camshaft gear; so the timing marks are
properly aligned. Install the washer and bolt. Torque
to specification.
NOTE: Be sure all timing marks are aligned.
Timing Marks
Timing Marks
Counterbalance Gear and Camshaft Gear Bolt:
22  2 ft-lbs (30  3 Nm)
= T