Head Lights (Incandescent); Headlight Adjustment; Headlamp Bulb Replacement - Polaris 2013 RANGER RZR S Service Manual

ELECTRICAL

HEAD LIGHTS (INCANDESCENT)

Headlight Adjustment

The headlight beam is adjustable.
1. Place the vehicle on a level surface with the headlight
approximately 25 ft. (7.6 m) from a wall.
2. Measure the distance from the floor to the center of
the headlight and make a mark on the wall at the same
height.
3. With the machine in Park, start the engine and turn the
headlight switch to on.
4. The most intense part of the headlight beam should
be aimed 8 in. (20 cm) below the mark placed on the
wall in Step 2.
NOTE: Rider weight must be included in the seat
while performing this procedure.
5. Adjust the beam to the desired position by loosening
the adjustment screw (A) and moving the lamp to the
appropriate height.
A
10.18
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
6. Adjust the beam to desired position. Repeat the
procedure to adjust the other headlight.
Due to the nature of light utility vehicles and
where they are operated, headlight lenses
become dirty. Frequent washing is necessary to
maintain lighting quality. Riding with poor
lighting can result in severe injury or death.

Headlamp Bulb Replacement

1. Disconnect the wire harness from the headlamp bulb.
Be sure to pull on the connector, not on the wiring.
2. Turn the bulb counterclockwise to remove it.
3. Insert new bulb. Reinstall the wire harness onto the
headlamp assembly.
4. Repeat steps 1-3 if replacing daytime running lights
(INT'L Only) also located in the headlamp housing.
NOTE: Make sure the tabs on the bulb locate
properly in the housing.
WARNING