Fuel Tank Removal (Rzr / Rzr S) - Polaris 2013 RANGER RZR S Service Manual

Hide thumbs Also See for 2013 RANGER RZR S:
Table of Contents

Advertisement

Fuel Tank Removal (RZR / RZR S)

IMPORTANT: Syphon as much fuel from the tank as
possible before attempting to remove it from the
vehicle.
WARNING
Always wear safety goggles when working with
high pressure or flammable fluids. Failure to do so
could result in serious injury or complications.
1. Remove the driver and passenger seats along with
the rear service panel.
2. Disconnect the negative battery cable from the battery
located under the driver's seat.
3. While holding a shop towel over the fuel line
connector, disconnect the quick connect fuel line from
the fuel pump. Move the fuel line out of the way for
tank removal.
NOTE: A small amount of fuel may come out of the
fuel line or tank. Properly drain fuel into a suitable
container.
4. Disconnect the fuel pump electrical harness.
Disconnect
Here
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
ELECTRONIC FUEL INJECTION
5. Remove fuel tank vent hose clamp with a suitable
pliers and remove vent line from the tank vent fitting.
6. Remove rear seat base assembly from the vehicle by
removing the (2) fasteners retaining the rear seat
base.
Rear seat base
assembly
7. Remove shift knob and center console from vehicle.
8. Remove the push rivets and screws retaining the RH
rocker panel and remove panel from the vehicle (see
Chapter 5).
Remove
RH Rocker Panel
4
4.25

Advertisement

Table of Contents
loading

This manual is also suitable for:

2013 ranger rzr 4

Table of Contents