Polaris 2013 RANGER RZR S Service Manual page 108

ENGINE / COOLING
32. Before installing the gear/stator housing cover, install
the Water Pump Seal Saver (PA-45401) onto the
water pump shaft.
PA-45401
33. Apply Crankcase Sealant (PN 2871557) to the
outside edges of the crankcase halves (see arrows),
where the crankcases mate (see the following
photos). This helps to prevent coolant leakage.
3.56
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
34. Install a new gear/stator housing gasket onto the
crankcase.
35. With both seal savers installed, carefully place the
gear/stator housing cover over the protection tools
and onto the crankcase.
36. Secure the gear / stator housing cover to the
crankcase with the cover bolts. Torque bolts in proper
sequence to specification. Remove seal protectors
from the shaft ends once the cover is secure.
Gear/Stator Housing Bolt:
96  12 in-lbs (10.85  1.35 Nm)
Torque in proper sequence
NOTE: Before assembly, clean the bolts and bolt
holes with Loctite Primer N (commercially available)
to remove any debris. This will ensure proper
sealing when installing bolts.
Gear / Stator
Housing Gasket
PA-45401
PA-45658
= T