Wheel Toe Alignment Inspection; Wheel Toe Adjustment - Polaris 2013 RANGER RZR S Service Manual

Hide thumbs Also See for 2013 RANGER RZR S:
Table of Contents

Advertisement

MAINTENANCE

Wheel Toe Alignment Inspection

1. Place machine on a smooth level surface and set
steering wheel in a straight ahead position. Secure
the steering wheel in this position.
2. Place a chalk mark on the center line of the front tires
approximately 10" (25.4 cm) from the floor or as close
to the hub/axle center line as possible.
NOTE: It is important the height of both marks be
equally positioned to get an accurate measurement.
3. Measure the distance between the marks and record
the measurement. Call this measurement "A".
4. Rotate the tires 180
Position chalk marks facing rearward, even with the
hub/axle center line.
5. Again measure the distance between the marks and
record.
Call
this
measurement "B" from measurement "A". The
difference between measurements "A" and "B" is the
vehicle toe alignment. The recommended vehicle toe
tolerance is 1/8" to 1/4" (.3 to .6 cm) toe out. This
means the measurement at the front of the tire (A) is
1/8" to 1/4" (.3 to .6 cm) wider than the measurement
at the rear (B).
Wheel Toe-Out:
(A) - (B) = 1/8 to 1/4" (.3 to .6 cm)
2.34
by moving the vehicle forward.
measurement
"B".
Subtract
= In. / mm.
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.

Wheel Toe Adjustment

If toe alignment is incorrect, measure the distance
between vehicle center and each wheel. This will tell you
which tie rod needs adjusting.
NOTE: Be sure steering wheel is straight ahead
before determining which tie rod needs adjustment.
During tie rod adjustment, it is very important that
the following precautions be taken when
tightening tie rod end jam nuts.
If the rod end is positioned incorrectly it will not
pivot, and may break.
To adjust toe alignment:
• Hold tie rod end to keep it from rotating.
• Loosen jam nuts at both end of the tie rod.
• Shorten or lengthen the tie rod until alignment is as
required to achieve the proper toe setting as
specified in "Wheel Toe Alignment".
CAUTION

Advertisement

Table of Contents
loading

This manual is also suitable for:

2013 ranger rzr 4

Table of Contents