Polaris 2013 RANGER RZR S Service Manual page 304

FINAL DRIVE
4. Lift bearing carrier into place and install the bolt
attaching the bearing carrier to the upper A-arm.
Torque fastener to specification.
Upper Rear Bearing Carrier Bolt:
RZR: 33 ft-lbs (45 Nm)
RZR S / RZR 4: 40 ft-lbs (54 Nm)
5. Apply grease to drive shaft axle splines.
6. Install rear wheel hub assembly, cone washers, and
hand tighten the castle nut. Install washers with
domed side out.
Cone Washers
Wheel
Hub
7. Install brake caliper mounting bolts and torque to
specification.
7.36
= T
Out
18 ft-lbs
24 (Nm)
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
Rear Caliper Mounting Bolts:
18 ft-lbs (24 Nm)
New bolts have a pre-applied locking agent
which is destroyed upon removal. Always use
new brake caliper mounting bolts
upon assembly.
8. Torque wheel hub nut to specification and install a
NEW cotter pin. Tighten nut slightly if necessary to
align cotter pin holes.
80 ft-lbs
(108 Nm)
Wheel Hub Castle Nut:
80 ft-lbs (108 Nm)
9. Install wheel and (4) wheel nuts. Torque wheel nuts
to specification.
Wheel Nuts:
Steel Wheels: 27 ft-lbs (37 Nm)
Aluminum Wheels: 30 ft-lbs + 90° (1/4 turn)
= T
CAUTION
NEW Cotter Pin
= T
= T