Polaris 2013 RANGER RZR S Service Manual page 102

ENGINE / COOLING
NOTE: Always install new balance shaft bearings.
4. Apply assembly lube to cam journals and balance
shaft bearing surfaces of the MAG case half. Install
camshaft and balance shaft.
5. Install crankshaft assembly and apply engine oil to
crank pins and rods (D). Apply assembly lube to the
main journals and bearings.
6. Apply Crankcase Sealant (PN 2871557) to the top half
of the crankcase.
NOTE: Do not apply sealant to cam relief hole (E).
3.50
D
E
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
7. Assemble the crankcase halves. Apply LocTite™ 242
(PN 2871949) to the threads and pipe sealant to the
bolt flanges. Torque bolts to specification following
torque pattern at beginning of this chapter.
Crankcase Bolts:
22  2 ft-lbs (30  3 Nm)
Torque in sequence
8. Lubricate cam lobes and valve lifters with Moly Lube
Grease.
Apply Moly Lube
Lifters
9. Lubricate lifters with engine oil and install in the
original order as removed in disassembly. Apply
Lubricant or Moly Lube to the ends of the lifters.
NOTE: Always replace camshaft and lifters as a set.
= T
Cam Lobes