Polaris 2013 RANGER RZR S Service Manual page 72

ENGINE / COOLING
19. Remove the rear stabilizer bar from the linkage on
both sides of the vehicle.
Standard RZR
Shown
20. Remove the (4) fasteners retaining the stabilizer bar
and bracket and remove the assembly from the
vehicle.
Standard RZR
Shown
21. Remove the engine breather hose from the valve
cover.
22. Loosen the hose clamp between the throttle body and
intake adaptor.
3.20
Loosen
Clamp
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
23. Disconnect the T-MAP, IAC and TPS sensor
connectors from throttle body.
24. Remove the remaining bolt attaching the airbox to the
frame (see photo).
25. Remove the airbox and throttle body from the vehicle
as an assembly. Take care in not allowing the throttle
cable to bend excessively or kink. Carefully place the
assembly on the floor next to the vehicle. Insert a shop
towel into the engine intake adaptor to prevent dirt
from entering the engine.
NOTE: Ensure throttle
excessively bent or kinked while removed from the
vehicle.
26. Mark the fuel injector harnesses to identify MAG and
PTO harness connections to aid during reassembly.
Disconnect the fuel injector harnesses.
cable is not being