Polaris 2013 RANGER RZR S Service Manual page 73

NOTE: The fuel injector harness connector and
locking spring is bonded to the fuel injectors with an
epoxy mix. DO NOT attempt to disconnect the
connector from the fuel injectors. Damage will occur
to the injector and/or harness if attempting to
separate at that location. Separate the fuel injector
from the vehicle by disconnecting at the end of the
harness as shown.
Fuel
Injector
Harness
DO NOT
Disconnect Here
IMPORTANT: Take note of PTO and MAG fuel injector
harness connectors before disconnecting them. The
harnesses are different and can not be connected
incorrectly (PTO - Gray; MAG - Black).
27. Disconnect the fuel line from the fuel injector rail by
slightly squeezing the lock tabs and gently pushing
the connector lock out. To separate the lines, pull the
fuel line from the tank strait down.
Squeeze locking tabs together
Push lock outward
Disconnect Here
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
ENGINE / COOLING
28. Disconnect the shift cable from the transmission bell
crank.
Remove
Clip
29. Mark the upper jam nut and loosen the lower jam nut.
Pull the shift cable out of the mount.
Mark Upper
Jam Nut
NOTE: If the upper jam nut is moved, shift cable
adjustment will be
installation (see Chapter 2 "Shift Cable Inspection /
Adjustment").
30. Disconnect the transmission gear indicator switch
harness.
Gear Switch
Connector
Lower
Jam Nut
required during engine
3.21
3