Polaris 2013 RANGER RZR S Service Manual page 71

11. Remove the (2) push rivets and remove the intake box
from the vehicle.
12. Elevate the rear of the vehicle off the ground using a
suitable ATV lift and remove both rear wheels.
13. Remove all exhaust components from vehicle and
engine.
14. Loosen the hose clamp attaching the outlet duct to the
PVT cover. Leave the duct attached to the upper
frame support.
Outlet Duct
15. Remove the (8) screws that retain the PVT cover and
remove cover.
Remove
Push Rivets
PVT Cover
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
ENGINE / COOLING
16. Remove the high tension leads from the spark plugs
and disconnect the ignition coil harness.
IMPORTANT: Mark or note which ignition coil wire
goes to which cylinder and ignition coil post. The
engine will misfire if the spark plug wires are installed
incorrectly. The spark plug wires are marked with PTO
and MAG from the factory and should be installed to
the corresponding cylinder and ignition coil post.
17. Remove the vent lines from the upper bolt-in frame
brace and plug vent lines to prevent fluid leakage
during removal.
18. Remove the (6) fasteners retaining the upper bolt-in
frame brace and remove it from the vehicle with the
ignition coil and PVT duct attached.
Frame Support
PVT Duct
Harness
Connection
3
Ignition
Coil
3.19