Polaris 2013 RANGER RZR S Service Manual page 131

Installation
IMPORTANT: When reinstalling the transmission to
rear gearcase mount bracket, it is extremely important
to torque all (7) fasteners to specification. Refer to the
following procedure.
NOTE: Special tool (PA-48873) will be required to
torque the mounting bracket fasteners when the
transmission and rear gearcase are installed in the
vehicle.
Special Tool
PA-48873
This tool is specifically designed to access
the critical transmission to rear gearcase
mounting bracket bolts on the RANGER
RZR when the transmission and rear
gearcase are installed in the vehicle. This
tool allows for proper torque to be applied to
½" SAE hex head cap screws with limited
wrench access. When used at a 90° angle
with a torque wrench, no torque multiplier
is necessary.
1. Clean bolt threads with solvent and allow them to dry.
Coat the circumference of the first 4 threads of the
®
bolts with Loctite 242
2. Reinstall mounting bracket and hand tighten the (7)
bolts.
3. Torque ALL mounting bracket bolts to specification.
Mount Bracket Bolt:
23-27 ft-lbs (31-37 Nm)
®
before installing the bolts.
= T
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
ELECTRONIC FUEL INJECTION
4. Using special tool (PA-48873), torque the (3) bolts
that retain the front portion of the mounting bracket to
the transmission.
Upper Transmission Bolt
Middle Transmission Bolt
Bottom Transmission Bolt
4
4.15