Polaris 2013 RANGER RZR S Service Manual page 75

37. Pivot the A-arms upward and rear hub carriers
downward and remove the drive shafts from the hub
carriers.
38. Grasp the rear drive shafts and pull sharply outward
on the shafts to disengage them from the rear
gearcase.
NOTE: Clean area around drive shaft orifices on
both sides of rear gearcase and cover orifices using
duct tape. This will prevent the lubricant from
leaking out during removal.
Hub Carrier
9924125 - 2013 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2012 Polaris Sales Inc.
ENGINE / COOLING
39. Disconnect the engine coolant temperature (ECT)
sensor harness and the bypass coolant hose.
ECT
Connector
Coolant
Bypass
40. Loosen the hose clamp and remove the lower coolant
hose from the water pump cover inlet and drain
coolant into a suitable container.
41. Remove the filler neck pressure cap to relieve the
cooling system vacuum.
NOTE: Use a portable wet-vac or syphon to prevent
any coolant from spilling.
42. Remove the upper coolant hose from the thermostat
housing outlet to relieve any coolant vacuum created
in the engine. Allow engine coolant to completely
drain. Properly dispose of the engine coolant /
antifreeze.
43. Remove the (+) positive battery cable from the starter
motor terminal and (-) negative battery cable from the
starter motor engine mount.
3
3.23