Clutch Alignment / Offset / Center Distance; Inspection - Polaris RANGER 500 2018 Service Manual

PVT SYSTEM

CLUTCH ALIGNMENT / OFFSET / CENTER DISTANCE

INSPECTION

1. Remove the outer PVT cover, drive belt, drive clutch
and driven clutch as outlined in this chapter.
The inner PVT cover does not need to be removed to
check the clutch center to center distance.
2. Install the Clutch Center Distance Tool onto the
crankshaft and transmission input shaft. The pictures
below show a properly installed tool.
Clutch Center Distance Tool
PU-50658 or PU-50658-A
5.12
NOTE
Images for Reference only. The tool shown should only
be used to check center to center distance.
The location the tool rests on the shafts may vary.
PU-50658–A
YEAR
HOLE
1 2012
2011-14
2014-15
2
2013
2014-16
2015-18
2015-16
3
2013–18
2014–18
2015-18
2014-18
2015-18
4
2016-18
2016–18
5 2015-18
i.e. 2015 RZR 900 uses the holes marked with a
3. If the tool fits as shown above, the clutch center to
center distance is correct.
4. If the tool does not fit as shown above, adjustment is
needed.
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
NOTE
VEHICLE DESCRIPTION
RZR 570
RZR 900
RZR XP 1000
RANGER 900
ACE
ACE 570
RGR ETX
RZR 570
RANGER 500/570
RANGER 570 Full-Size
RANGER 900/1000
RZR 900
RZR 1000
ACE 900
RANGER Diesel
4
© Copyright Polaris Industries Inc.