Meridian Link/Customer Controlled Routing Installation And Upgrade Manual page 541

13 Replace the six screws and flat washers, reattaching the CPU card
to the Options 21Ð81 IPE Module frame.
14 Insert the Options 21Ð81 bracing support.
This bracing support sits inside the module between the CPU and
disk drive cards. Hold the support with one hand while inserting the
screw into the CPU board with the other.
15 Turn the CPU card and frame over and reconnect the disk drive card
to the CPU card by connecting the power cable to the CPU card at
connector J5.
16 Connect the disk drive cardÕs SCSI I/O cable to the CPU card at
connector J14. Make sure the SCSI plugÕs key bumps are lined up
correctly and the latches are closed.
Note: To install the IPE Module, refer to Table 11 in Chapter 5,
ÒHardware installation overview.Ó
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Chapter 17: Hardware upgrade 523