Enable Esdi Port (X81 Phase 7 Or X11 Release 17) - Meridian Link/Customer Controlled Routing Installation And Upgrade Manual

302 Chapter 12: Meridian 1 configuration for Meridian Link/CCR

Enable ESDI port (X81 phase 7 or X11 Release 17)

553-3202-210 Standard October 1998
Commands in LD 48 require a port or link parameter, which is indicated in
the prompts as xx. Substitute the appropriate port or link number when
using the prompts listed below.
Table 107
LD 48ÑLink Diagnostic
Command
ACMS xx
The following commands may be used for diagnostic purposes:
CON ESDI xx
DIS ESDI xx
DIS MSGI xx
DIS MSGO xx
DSC ESDI xx
ENL ESDI xx
ENL MSGI xx
ENL MSGO xx
ENXP MSGO xx
yy
ENXP MSGI xx yy
ENL MSGI/MSGO
xx
Comment
Enable and start the ESDI link on port xx
Configure link layer for ESDI port xx using HDLC
protocol
Disable ESDI on port xx
Turn off link monitoring for incoming messages on
link xx
Turn off link monitoring for outgoing messages on
link xx
Disconnect the link to ESDI on port xx
Enable ESDI on port xx
Turn on link monitoring for incoming messages on
link xx
Turn on link monitoring for outgoing messages on
link xx
Exclude polling on link xx for outgoing messages
with priority levels yy
Exclude polling on link xx for incoming messages
with priority levels yy
Enable message input/output monitoring (xx=link)
ÑcontinuedÑ