Table of Contents
Advertisement
454 Chapter 14: Software installation, upgrade, and update procedures
553-3202-210 Standard October 1998
Procedure 7: Reboot and go through setup (continued)
9
At the ÒEnter zone number:Ó prompt, type the number corresponding
to your time zone and press [Return].
If your time zone is not listed in time zones 1Ð12, type 13 and press
[Return]. You will see explanatory messages. At the ÒEnter 3-letter
time-zone-nameÓ prompt (Figure 210), type three letters to represent
your time zone and press [Return]. At the ÒEnter time difference from
GMTÓ prompt, type the difference between your local time and
Greenwich Mean Time (GMT). Use a minus if your time zone is west
of GMT.
Figure 210
Additional time zone menu
Enter 3-letter time-zone-name (a thru z or A thru Z)
Enter time difference from GMT (use Ò-Ó if west of GMT)
Figure 211
DST prompt
Does your time zone use Daylight Savings Time during the year? [y, n, ?, q]
10
You are prompted to indicate whether your time zone uses Daylight
Savings Time during the year. Type in your response (y if Daylight
Savings Time applies, n if it does not) and press [Return].
The system response reflects whether or not the Daylight Savings
Time selection was changed.
Figure 212
Date and time change prompt
Time zone now changed.
Note:
Any logins and processes running when the time zone changes, and
all their child processes, will continue to see the old time zone.
The cron will be restarted at the end of this procedure.
Current date and time:
Change the date and time? [y, n, ?, q]
Tue. 06/29/93 09:37
Hide quick links:
Advertisement
Table of Contents
