Enable Esdi Or Msdl Port (X11 Release 18 Or Later) - Meridian Link/Customer Controlled Routing Installation And Upgrade Manual

312 Chapter 12: Meridian 1 configuration for Meridian Link/CCR

Enable ESDI or MSDL port (X11 Release 18 or later)

553-3202-210 Standard October 1998
Commands in LD 48 require a port or link parameter, which is indicated in
the prompts as xx. Substitute the appropriate port or link number when
using the prompts listed below.
Table 110
LD 48ÑLink Diagnostic
Command
ENL AML xx ACMS
ENL AML xx
The following commands may be used for diagnostic purposes:
STAT AML xx
ENL AML xx aaa
ENL MSGI/MSGO
xx
DIS MSGI/MSGO
xx yy
Comment
Enable the AML on port xx (ESDI only)
Enable the AML on port xx (MSDL only)
Show the status of the AML link.
Enable link xx or option aaa. Options include
(none) - no additional option
LYR2 - enable link layer 2
(MSDL must be enabled first)
FDL - forced download of AML software
(MSDL must be enabled and all AML
I/O ports disabled first)
AUTO - enable auto recovery of AML
(MSDL only)
LYR7 - enable application layer (7)
(AML must be established first)
MDL - enable MDL error reporting (MSDL only)
(AML must be enabled first)
MON - enable debug monitoring (MSDL only)
(AML must be enabled first)
ACMS - enable and start the AML on port xx
(ESDI only)
Enable message input/output monitoring (xx=link)
Disable message input/output monitoring (xx=link,
yy=priority)
Ñ continued Ñ