Meridian Link/Customer Controlled Routing Installation And Upgrade Manual page 318

300 Chapter 12: Meridian 1 configuration for Meridian Link/CCR
553-3202-210 Standard October 1998
Table 106
LD 17ÑConfigure ESDI port (Options 21Ð81) (continued)
Prompt Response
DUPX FULL
BPS 19200
CLOK INT
IADR 3
RADR 1
LCTL YES
T1 4
T2 0
T3 10
N1 128
N2 8
K 1Ð(7)
LTHR <cr>
USER CMS
ADAN <cr>
VAS NEW
VSID 0Ð15
DLOP <cr>
Comment
Full duplex mode
19,200 bps baud rate (19.2 kbps). (The
baud rate for link 0 of the Application Module
must also be set to 19,200 bps.)
Internal clock
Internal address for AML LAPB
Remote address for AML LAPB
Modify link control parameters
Layer 2 retransmission timer in units of 0.5
seconds
Layer 2 acknowledge timer in units of 0.5
seconds
Layer 2 link set-up timer in units of 0.5
seconds (only for ESDI)
Maximum I frame length in octet
Maximum number of Layer 2 retransmission
Maximum number of outstanding frames
Note: This number must match the value
set for Link 0 on the Meridian Link.
ESDI port is a Command and Status link
Value Added Server Identifier (VAS ID)
VAS (AML) identifier
ÑcontinuedÑ