Meridian Link/Customer Controlled Routing Installation And Upgrade Manual page 503

Procedure 13: Changing AML (link 0) parameters (continued)
3 Type change link 0 and press [Return] to begin making changes to
the link.
The first parameter appears, along with possible and current values.
Note: All the fields displayed in Figure 260 except for ÒLink typeÓ and
ÒPort typeÓ may be changed by executing the Òchange link xÓ
command.
Figure 260
Change link parameters
Machine ID
Current SL16
>
4 To change the parameter, type the new value and press [Return]. To
leave the parameter unchanged, just press [Return].
Refer to Table 141 for information on link parameters.
5 Continue with remaining parameters until the ÒConfirm (yes or no)Ó
prompt appears.
6 To confirm the changes, type yes and press [Return].
If you made a mistake and wish to redo your changes, type no,
press [Return], and restart this procedure from step 3.
At this point, the changes you have made are temporary. They are
saved in memory, but not on disk (which means that if the system is
restarted, the changes are lost).
7 To save your changes, go to the appropriate procedure:
¥ Procedure 16: Replacing the default configuration file
¥ Procedure 17: Creating a configuration file
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Chapter 15: Link configuration 485