Table of Contents
Advertisement
Chapter 14: Software installation, upgrade, and update procedures 393
Procedure 1: Application configuration and start-up (continued)
Figure 108
Ethernet connection prompt
Installing NSE R3V7.1. Please wait.
Is your module connected to the Ethernet (y/n) ?
17
You are asked whether your Application Module or IPE Module is
connected to Ethernet (Figure 108).
For more information about Ethernet connections, refer to Chapter 9,
ÒMeridian Link/CCR interface cablingÓ.
If your module is not connected to Ethernet, type n and press
[Return]. Go to step 21.
If you are connected to Ethernet and you plan to use it in the near
future, type y and press [Return]. You see a message asking you to
wait. Then you see more installation messages (Figure 109). Go to
step 18.
If you are connected to Ethernet but do not plan to use it in the near
future, you may choose to type n and press [Return]. Disabling
Ethernet support increases the processing power available to your
application(s). Go to step 21.
If you disable Ethernet support, you must perform a complete
reinstallation of the base operating system and application(s) before
you can reenable Ethernet support.
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
ATTENTION
Hide quick links:
Advertisement
Table of Contents
