Meridian Link/Customer Controlled Routing Installation And Upgrade Manual page 413

Chapter 14: Software installation, upgrade, and update procedures 395
Procedure 1: Application configuration and start-up (continued)
Figure 111
Module address prompt
Enter the MODULE ADDRESS to be added to the tcpip transport provider database
(?, or module address):
19 You are prompted for the address of the Application Module or IPE
Module (Figure 142). Type the module address and press [Return].
The module address must be four numbers separated by periods,
such as Ò12.234.67.89Ó. For more information about module
addresses, consult your network administrator.
Figure 112
Reenter prompt
If you made any mistakes in entering the module name and IP address, you can
correct them. Would you like to re-enter the module name or IP address? [y,n]:
20 You are asked whether you want to reenter the module name or
address (Figure 112).
If you have not made a mistake, type n and press [Return]. Go to
step 21.
If you want to reenter the module name and address, type y and
press [Return]; you will return to step 18.
Figure 113
Reboot prompt
Entry for <module name> with address <address> added to tcpip transport provider
database.
Now your system has been modified. You must reboot the system to have the new
kernel take effect.
Would you like to reboot the system now (y/n) ?
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide