Meridian Link/Customer Controlled Routing Installation And Upgrade Manual page 207

Cabling for the first four PE slots can be expanded using one NT8D81AA
cable/filter assembly. Cabling for all of the PE slots can be expanded using
three NT8D81AA cable/filter assemblies.
If you do not have additional NT8D81AA cable/filter assemblies available,
you can reroute the existing cables to accommodate the Meridian Link/CCR
IPE Module in certain PE slots. For more information on this, refer to
ÒNT8D11 backplane cabling reroutingÑto accommodate the IPE Module in
PE slots 0Ð3Ó later in this section.
NT8D11 backplane cable expansionÑfirst four PE slots only
With the cables located as shown in Table 64:
1 Leave cable A in slot position L0.
2 Move cable end B-3 from slot position L2-1 to slot position L1-3.
3 Remove cable C from the backplane and connect cable ends C-1,
C-2, and C-3 to slot positions L2-1, L2-2, and L2-3.
4 Add cable D to the I/O panel by connecting cable ends D-1, D-2, and
D-3 to slot positions L3-1, L3-2, and L3-3.
Cables E, G, H, and K remain the same. Cable positions G and L
are open for further expansion.
Slots 0Ð3 are now ready to receive an IPE Module.
NT8D11 backplane cable expansionÑall PE slots
With the cables located as shown in Table 64:
1 Leave cable A in slot position L0.
2 Move cable end B-3 from slot position L2-1 to slot position L1-3.
3 Remove cable C from the backplane and connect cable ends C-1,
C-2, and C-3 to slot positions L2-1, L2-2, and L2-3.
4 Add cable D to the I/O panel by connecting cable ends D-1, D-2, and
D-3 to slot positions L3-1, L3-2, and L3-3.
5 Move cable end E-3 from slot position L5-1 to slot position L4-3.
6 Remove cable F from the backplane and connect cable ends F-1,
F-2, and F-3 to slot positions L5-1, L5-2, and L5-3.
7 Add cable G to the I/O panel by connecting cable ends G-1, G-2,
and G-3 to slot positions L6-1, L6-2, and L6-3.
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Chapter 9: Meridian Link/CCR interface cabling 189