Meridian Link/Customer Controlled Routing Installation And Upgrade Manual page 108

90 Chapter 5: Hardware installation overview
Table 12
Installing an Application Module
1. Go through Chapter 6, ÒSite survey/installation checklist.Ó
2. Go through Chapter 7, ÒUnpack and inspect hardware.Ó
3. Install an ESDI or MSDL card (if required). See Chapter 8,
ÒHardware installation procedures.Ó
4. Install the AEM (Application Equipment Module), if
required.
5. Check the transition card option settings (if necessary).
See Chapter 8, ÒHardware installation procedures.Ó
6. Install the Application Module. See Chapter 8, ÒHardware
installation procedures.Ó
7. Cable to external equipment. See Chapter 9, ÒMeridian
Link/CCR interface cabling.Ó
8. Install the peripheral devices. See Chapter 10, ÒInstalling
peripheral devices.Ó
9. Configure the Meridian 1. See Chapter 12, ÒMeridian 1
configuration for Meridian Link/CCR.Ó
10. Configure the links. See Chapter 15, ÒLink configuration.Ó
11. Install the base operating system and the applications. See
Chapter 14, ÒSoftware installation, upgrade, and update
procedures.Ó
12. Configure the applications. See Chapter 16, ÒAdditional
application configuration.Ó
553-3202-210 Standard October 1998
Procedure Reference
Page 91
Page 115
Page 142 (SDI/DCH)
Page 145 (ESDI or MSDL)
Refer to the Application
Equipment Module
Installation Guide
(NTP 553-3201-200).
Page 119
Page 125
Page 227
Page 261
Page 293
Page 479
Page 371
Page 503