Table of Contents
Advertisement
Figure 43
IPE Module Option 11 connections (Part 2)
Meridian 1 Option 11
NTAK02
Internal
SDI/DCH
bus
port 0
port 1
port 2
port 3
Method 3
port 0
port 2
NTAK19BA
(4-port
cable)
port 1
port 3
J2-9
(Note 1)
Note 1:
It is recommended that the TDS/DTR card be
installed in position 1. The SDI/DCH card may be
installed in any other position except position 0
(for the CPU/Conf card).
Note 2:
Refer to the Meridian 1 Option 11 Installation
Guide (NTP 553-3011-210) for cross connections.
Note 3:
Use an NT1R03D extension cable if you need
additional length.
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Chapter 9: Meridian Link/CCR interface cabling 171
1
3
NT1R03AA
5
(octopus
7
cable)
Connect an SDI port to port 3 for
conshare and an ESDI port to
port 5 for AML (link 0) (Note 3)
IPE
Module
Connector
Panel
NT1R03CA
(extension
cable)
Hide quick links:
Advertisement
Table of Contents
