Input/Output Cables - Meridian Link/Customer Controlled Routing Installation And Upgrade Manual

Input/output cables

Table 77
Internal I/O cables (Application Module)
Part number
NT7D52AA
(A0372656)
NT7D53AA
(A0372657)
NT7D56AC
(A0404311)
NT7D57AA
(A0372913)
NT7D76AA
(MVME712A/AM
only)
NT8D46AA
(A0356972)
The Application Module has two types of I/O cable. These include
¥ internal cables that connect circuit cards to disk and tape drives within
the Application Module
¥ external cables that connect the Application Module to the
Meridian 1, the system console, and application terminals (if
applicable)
Internal I/O cables
Internal cables interconnect components that are not connected through the
VME bus backplane. Table 77 lists the Application Module internal cables.
Figure 58 shows the internal cabling scheme.
Cable description and application
Power monitor cableÑ3-pin connector, yellow and gray twisted wire cable:
carries signals from the power sense card (P1) to the power monitor (P1 for
a left-hand Application Module, P2 for a right-hand Application Module)
SCSI cableÑ50-pin connector cable: carries the SCSI interface from the
floating connectors (J3) to the disk/tape drives (J1)
SCSI extension cableÑ50-pin connector cable: carries the SCSI interface
from the adapter board (J3) to the external SCSI I/O port (via the
MVME712M card) and the disk/tape unit (P3)
J2 output cableÑ64-pin connector, flat ribbon cable: carries I/O from the
MVME333-2 XCC card to the MVME705B transition card, from the P2
adapter board (J2) to the MVME712M transition card (J2), and from the
MVME332XTS ACC card to the NT6D51AA transition card
Adapter board to transition card cableÑ64-pin connector, flat ribbon cable:
carries I/O from the adapter board (J2) to the MVME712 transition card
(J11)
System monitor cableÑ40-pin connector cable: carries signals from the
power monitor (J1, J2) to the system monitor in the column
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Chapter 9: Meridian Link/CCR interface cabling 219