Meridian Link/Customer Controlled Routing Installation And Upgrade Manual page 37

Ñ QPC513 Enhanced Serial Data Interface (ESDI) card (vintage G or
later)
Ñ NT6D80 Multi-purpose Serial Data Link (MSDL) card
Ñ (Option 11 only) NTAK02AB Serial Data Interface/D-Channel
Interface (SDI/DCH) card
Ñ If using a redundant Meridian Link, two AML connections are
required.
¥ a Serial Data Interface (SDI) card if conshare capability is desired
Note: Conshare capability, which gives you access to MeridianÊ1
input/output programs from the Meridian Link console, is
recommended to allow for more effective support for your system.
Option 11 systems support an SDI port on any of the following cards:
Ñ the CPU/CONF card (NTAK01AB)
Ñ the SDI/DCH card (NTAK02AB)
Ñ the TDS/DTR card (NTAK03AB)
¥ for optional voice-processing capability, a Meridian Mail system
¥ limited-distance modems for communications facilities if the IPE
Module or the Application Module is greater than 15 m (50 ft) from the
host computer
An Application Equipment Module (AEM), if present, must be installed in
one of the following configurations:
¥ a stand-alone AEM column or Meridian SL-1 style cabinet
¥ a module in a Meridian 1 column
Refer to Application Equipment Module Installation Guide
(NTP 553-3201-200) for AEM installation procedures.
The following table shows hardware supported for the Meridian Link and
CCR applications.
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Chapter 2: Overview of Meridian Link 19