Table of Contents
Advertisement
400 Chapter 14: Software installation, upgrade, and update procedures
Application tape
2
of
2
Tape
Notch
points down
553-3202-210 Standard October 1998
Procedure 3: Load application software from tape (continued)
1
Insert the tape (marked Tape 2 of 2) into the tape drive as shown in
Figure 119.
Ensure that the tape drive latch (if present) is fully closed after the
tape is inside. Once the tape is inserted correctly and the latch
completely closed, the tape active indicator light will come on briefly,
flicker a few times, then go out again.
Figure 119
Inserting cassette tape in tape drive
IPE Module drive
Arrow
points in
in
side
This
button
Eject
Application Module drive
Lock the tape drive latch
after tape is inserted
Hide quick links:
Advertisement
Table of Contents
