Table of Contents
Advertisement
388 Chapter 14: Software installation, upgrade, and update procedures
Procedure 1: Application configuration and start-up
553-3202-210 Standard October 1998
1
Set the Application Module circuit breaker or the IPE Module power
pushbutton to ON (if it is not already on).
Wait for the system to boot UNIX from the hard disk. If the ÒConsole
Login:Ó prompt does not appear, refer to the Application Module and
Intelligent Peripheral Equipment Module Diagnostic and
Maintenance Guide (NTP 553-3211-510).
2
Type maint and press [Return] at the ÒConsole Login:Ó prompt to log
in as the maintenance user.
3
You are prompted to enter a password. Type the password for the
maint account and press [Return]. The password for maint is maint.
4
At the Òmaint>Ó prompt, type install and press [Return].
Figure 96
Tape prompt
You can reconfigure the system using a keycode without a tape or you can use a
tape to upgrade the software and reconfigure. Do you want to use a tape (y/n/q)?
5
You are prompted to use a tape (Figure 96). Type n and press
[Return].
Figure 97
Meridian 1 ID prompt
Please enter the Meridian 1 ID of this site
(or Q or q to quit):
6
You are prompted to enter your Meridian 1 ID (Figure 97). Type your
ID and press [Return].
Hide quick links:
Advertisement
Table of Contents
