Meridian Link/Customer Controlled Routing Installation And Upgrade Manual page 504

486 Chapter 15: Link configuration
Table 141
AML (link 0) parameters
Link parameter
Protocol*
Link type*
Machine ID
Delay
Port type*
Physical DTE/DCE
PDN type
Note: Parameters marked with an asterisk (*) cannot be changed.
553-3202-210 Standard October 1998
Procedure 13: Changing AML (link 0) parameters (continued)
Allowed values
(defaults in parentheses)
(HDLC)
(1)
(SL16)
(0)Ð9999
(H)
0, 1
0, 40Ð48
Ñ continued Ñ
Description
Link protocol used
Type of link (1=AML)
Logical name assigned to the
attached Meridian 1
Maximum time (in seconds)
between packet transmissions
H=HDLC
0 if link port is configured as
DTE; 1 if the port is configured
as DCE
Packet data network type. This
parameter is dependent on the
type of network configured.
The possible values are:
0 Ñ LAPB
40 Ñ Datex-P (Germany)
41 Ñ Transpac (France)
42 Ñ PPS (United Kingdom)
43 Ñ Datapak (Sweden)
44 Ñ Telenet (USA)
45 Ñ DDN (USA)
46 Ñ Accunet (USA)
47 Ñ Datapac (Canada)
48 Ñ Tymnet (USA)
The default values are 0 for
LAPB and 44 for X.25.