Digital Projection
Titan Pro series III
Operating the Projector
Switching the Projector On
•
Connect the power cable between the mains supply and the projector. Switch on at the switch next to the power connector.
•
Wait until the self-test has completed and the standby indicator on the projector control panel shows amber. The lamp will be off and the
projector will be in STANDBY mode.
•
Press
on the remote control or the control panel and hold for 3 seconds, to switch the projector ON. The power indicator on the
control panel will show green, the lamp will light and the shutter will open.
Selecting an Input Signal or Test Pattern
Input signal
•
Connect an image source to the projector. The signal should be automatically detected by the
projector, and should be displayed within a two or three seconds.
If more than one signal is connected, then select the image you want to display:
•
Press one of the
,
Input buttons
•
Open the
, by pressing
Main Menu
•
Select from the
Input Selection menu
Test pattern
If you have no image source connected to the projector, then you can display a test pattern instead:
•
Open the
, by pressing
Main Menu
•
Select
from the
Test Pattern
Input Selection menu
•
Select a pattern from the
Test Pattern menu
•
Close the
, by pressing
Main Menu
Rev A May 2012
OPERATING THE PROJECTOR
to
or
(dual pipe) on the remote control, or
.
, using the
and
buttons.
.
, using the
and
, using the
and
again.
buttons.
buttons.
Installation and Quick-Start Guide
Notes
For full details of how to use the
controls and the menu system, see
the Operating Guide.
Page Inst_9