Operating The Projector; Switching The Projector On; Selecting An Input Signal Or Test Pattern; Input Signal - Digital Projection Titan Pro Series 3 Installation And Quick Start Manual

Digital Projection
Titan Pro Series 3

Operating The Projector

Switching the projector on

•
Connect the power cable between the mains supply and the projector. Switch on at the switch next to the power connector.
•
Wait until the self-test has completed and the standby indicator on the projector control panel shows amber. The lamp will be off and the
projector will be in STANDBY mode.
•
Press on the remote control or the control panel and hold for 3 seconds, to switch the projector ON. The power indicator on the
control panel will show green, the lamp will light and the shutter will open.

Selecting an input signal or test pattern

Input signal

•
Connect an image source to the projector. The signal should be automatically detected by the projector,
and should be displayed within two or three seconds.
If more than one signal is connected, then select the image you want to display:
•
Press one of the ,
Input buttons
•
Open the On-screen display (OSD) by pressing
•
Select an input signal from the Input Selection

Test pattern

If you have no image source connected to the projector, then you can display a test pattern instead:
•
Open the OSD by pressing .
•
Select Test Pattern from the Input Selection
•
Select a pattern from the Test Pattern
•
Close the OSD by pressing
Rev D November 2012
to or (dual pipe) on the remote control, or
.
menu, using the
menu, using the
menu, using the and
again.
OPERATING THE PROJECTOR
and buttons.
and buttons.
buttons.
Installation and Quick-Start Guide
Notes
Inputs 9-11 are available on 3D
models only.
For full details of how to use the
controls and the menu system, see
the Operating Guide.
Inst 9