Selecting An Input Signal Or Test Pattern; Input Signal; Test Pattern - Digital Projection M-Vision Cine 400 3D series User Manual

Digital Projection
M-Vision Cine 400 3D series

Selecting an input signal or test pattern

Input signal

Connect an image source to the projector. The signal should be automatically detected by the projector, and should be displayed within
two or three seconds.
If more than one signal is connected, select the image you want to display in one of the following ways:
● Access the Main menu (either from the remote control or from the control panel) and then go to Input Select.
● On the remote control, select from the inputs using the number buttons
● On the control panel, press
SOURCE

Test pattern

If you have no image source connected to the projector, you can display a test pattern instead. To display a test pattern, do either of the
following:
● Press the TEST button on the remote control to cycle through all test patterns.
TEST
● Access the Service menu and select a test pattern.
Revision C, July 2014
OPERATING THE PROJECTOR
1
to cycle through all the inputs.
to
6
Installation and Quick-Start Guide
Notes
For full details of how to use the
controls and the menu system,
see the Operating Guide.
Inst-09