Using The Remote Control And The Control Panel - Digital Projection Titan Pro Series III User Manual

Digital Projection
Titan Pro series III

Using the Remote Control and the Control Panel

40°
Infra-red
reception
Info
displays information
about the current signal
40°
Menu
controls
Input selection
1 – 10 selects Inputs 1 to 10
selects Dual Pipe (inputs 9+10)
#
Image adjustment
, and
Brightness Contrast Saturation
use and to adjust sliders
OSD
opens the OSD menu
Pos
use and to adjust
H and V sliders
Remote control
backlight On/Off
Rev A May 2012
USING THE REMOTE CONTROL AND THE CONTROL PANEL
Transmit
indicator
Power
On/Off
OSD On/Off
both open the Messaging
selection menu
Shutter Open/Close
(RPY) Lens calibration
See Fitting the Lens in the
Installation and Quick Start Guide.
Lens controls
Press Focus , then and to adjust.
Press then and to adjust.
Zoom
Press Shift then , , and
Input selection
Press or to scroll through the inputs
+ –
Magnify and Pan
both open the
Pan/Scroll/Zoom
Phase (VGA only)
use and to adjust slider
Aspect
opens the menu
Aspect Ratio
Notes
For full details of how to use the
menu system, see later in this guide.
When you press any of the L
control buttons, the
indicator will stay illuminated for 10
seconds, or until you press
Each time a lens is fitted to
the projector, the calibration
procedure must be carried out.
(see the Installation and Quick
Start Guide)
After calibrating the lens, you will
need to re-adjust the Zoom and
to adjust.
Focus.
Some of the buttons are duplicated
on the control panel:
menu
Operating Guide
ens
Transmit
.
Exit
Page Op_1