Installing The Dual-Port Network Adapter - Lenovo x3550 M4 Installation And Service Manual

Figure 49. RAID adapter battery or flash power module installation
Results
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 92.

Installing the dual-port network adapter

You can purchase one of the following dual-port network adapters to add two
additional network ports in the server.
About this task
To order a dual-port network adapter option, contact your sales representative or
reseller.
a. Release the retention clip in the open position.
b. Align the cable connector with the slot on the holder. Place the battery or
flash power module into the holder and make sure that the holder engages
the battery or flash power module securely.
Note: The positioning of the battery or flash power module depends on the
type of the battery or flash power module that you install.
c. Connect the other end of the cable to the battery or flash power module.
d. Lower and press down on the retention clip until it snaps in place to hold
the battery or flash power module firmly in place.
Chapter 2. Installing optional devices
65