Lenovo x3550 M4 Installation And Service Manual page 356

40000024-00000000 • 40000028-00000000
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is
required.
40000024-00000000 Flash of [arg1] from [arg2] failed
for user [arg3].
Explanation: This message is for the use case where a
user has not flashed the firmware component from the
interface and IP address due to a failure.
May also be shown as 4000002400000000 or
0x4000002400000000
Severity: Info
Alert Category: System - other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0036
SNMP Trap ID: 22
Automatically notify Support: No
User response: Information only; no action is
required.
40000025-00000000 The [arg1] on system [arg2] is
75% full.
Explanation: This message is for the use case where a
Management Controller Event Log on a system is 75%
full.
May also be shown as 4000002500000000 or
0x4000002500000000
Severity: Info
Alert Category: System - Event Log 75% full
Serviceable: No
CIM Information: Prefix: IMM and ID: 0037
SNMP Trap ID: 35
Automatically notify Support: No
User response: Information only; no action is
required.
40000026-00000000 The [arg1] on system [arg2] is
100% full.
Explanation: This message is for the use case where a
Management Controller Event Log on a system is 100%
full.
May also be shown as 4000002600000000 or
0x4000002600000000
Severity: Info
Alert Category: System - Event Log 75% full
338
System x3550 M4 Type 7914: Installation and Service Guide
Serviceable: No
CIM Information: Prefix: IMM and ID: 0038
SNMP Trap ID: 35
Automatically notify Support: No
User response: To avoid losing older log entries, save
the log as a text file and clear the log.
40000027-00000000 Platform Watchdog Timer expired
for [arg1].
Explanation: This message is for the use case when an
implementation has detected a Platform Watchdog
Timer Expired
May also be shown as 4000002700000000 or
0x4000002700000000
Severity: Error
Alert Category: System - OS Timeout
Serviceable: No
CIM Information: Prefix: IMM and ID: 0039
SNMP Trap ID: 21
Automatically notify Support: No
User response: Complete the following steps until the
problem is solved:
1. Reconfigure the watchdog timer to a higher value.
Make sure that the IMM Ethernet-over-USB
2.
interface is enabled.
Reinstall the RNDIS or cdc_ether device driver for
3.
the operating system.
Disable the watchdog.
4.
Check the integrity of the installed operating
5.
system.
40000028-00000000 Management Controller Test
Alert Generated by [arg1].
Explanation: This message is for the use case where a
user has generated a Test Alert.
May also be shown as 4000002800000000 or
0x4000002800000000
Severity: Info
Alert Category: System - other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0040
SNMP Trap ID: 22
Automatically notify Support: No
User response: Information only; no action is
required.