Lenovo x3550 M4 Installation And Service Manual page 124

v User Security
v Save Settings
v Restore Settings
v Load Default Settings
v Exit Setup
Passwords
From the User Security menu choice, you can set, change, and delete a power-on
password and an administrator password.
The User Security choice is on the full Setup utility menu only.
If you set only a power-on password, you must type the power-on password to
complete the system startup and to have access to the full Setup utility menu.
An administrator password is intended to be used by a system administrator; it
limits access to the full Setup utility menu. If you set only an administrator
password, you do not have to type a password to complete the system startup, but
you must type the administrator password to access the Setup utility menu.
If you set a power-on password for a user and an administrator password for a
system administrator, you can type either password to complete the system
106
System x3550 M4 Type 7914: Installation and Service Guide
– Clear System Event Log
Select this choice to clear the system event log.
Select this choice to set, change, or clear passwords. See "Passwords" for more
information.
This choice is on the full and limited Setup utility menu.
– Set Power-on Password
Select this choice to set or change a power-on password. See "Power-on
password" on page 107 for more information.
– Clear Power-on Password
Select this choice to clear a power-on password. See "Power-on password" on
page 107 for more information.
– Set Administrator Password
Select this choice to set or change an administrator password. An
administrator password is intended to be used by a system administrator; it
limits access to the full Setup utility menu. If an administrator password is
set, the full Setup utility menu is available only if you type the administrator
password at the password prompt. See "Administrator password" on page
108 for more information.
– Clear Administrator Password
Select this choice to clear an administrator password. See "Administrator
password" on page 108 for more information.
Select this choice to save the changes that you have made in the settings.
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
Select this choice to cancel the changes that you have made in the settings and
restore the factory settings.
Select this choice to exit from the Setup utility. If you have not saved the
changes that you have made in the settings, you are asked whether you want to
save the changes or exit without saving them.