Lenovo x3550 M4 Installation And Service Manual page 315

Removing the operator information panel assembly
Use this information to remove the operator information panel assembly.
About this task
To remove the operator information panel, complete the following steps.
Procedure
1. Read the safety information that begins on "Safety" on page vii and
"Installation guidelines" on page 33.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables, if necessary.
3. Remove the cover (see "Removing the cover" on page 36).
4. Disconnect the cable from the back of the operator information panel assembly.
5. Pull up the blue points slightly on the rear of the panel toward the front of the
server.
Figure 210. Operator information panel removal
6. From the front of the server, carefully pull the assembly out of the server while
you move it slightly from side to side.
Results
If you are instructed to return the operator information panel assembly, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Replacing the operator information panel assembly
Use this information to replace the operator information panel assembly.
About this task
To install the operator information panel, complete the following steps.
Procedure
1. Read the safety information that begins on "Safety" on page vii and
"Installation guidelines" on page 33.
Chapter 6. Removing and replacing components
297