Lenovo x3550 M4 Installation And Service Manual page 265

Attention:
v You can not install ServeRAID H1110 when microprocessor Intel Xeon E5-2637
(FRU part number 49Y8124) is installed.
v You can not install ServeRAID M1115 or IBM 6Gb performance optimized HBA
when Quadro 2000 is installed.
You can replace the ServeRAID controller with another supported ServeRAID
controller. For a list of supported ServeRAID controllers, see http://
www.ibm.com/systems/info/x86servers/serverproven/compat/us/.
Note: For brevity, in this documentation the ServeRAID SAS/SATA controller is
often referred to as the SAS/SATA adapter or the ServeRAID adapter.
Procedure
1. Read the safety information that begins on "Safety" on page vii and
"Installation guidelines" on page 33.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the cover (see "Removing the cover" on page 36).
4. Remove PCI riser-card assembly 1 if necessary (see "Removing a PCI
riser-card assembly" on page 236).
5. If you are installing a new or replacement SAS/SATA adapter, touch the
static-protective package that contains the new SAS/SATA adapter to any
unpainted metal surface on the server. Then, remove the new SAS/SATA
adapter from the package.
6. Align the SAS/SATA adapter so that the keys align correctly with the
connector on the system board.
7. Insert the SAS/SATA adapter in the dedicated connector on the system board
or PCI riser-card slots.
Attention: Incomplete insertion might cause damage to the server or the
adapter.
a. Insert the SAS/SATA adapter into the RAID connector on the system
board until it is firmly seated. The retention brackets secure the SAS/SATA
adapter in place when the adapter is firmly seated into the connector.
Note: Remove the PCI bracket that come with ServeRAID H1110,
ServeRAID M1115, or ServeRAID M5110 SAS/SATA adapter before
installing a SAS/SATA adapter in the dedicated connector on the system
board.
Chapter 6. Removing and replacing components
247