Lenovo x3550 M4 Installation And Service Manual page 354

4000001b-00000000 • 4000001e-00000000
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is
required.
4000001b-00000000 Management Controller [arg1]:
Configuration restored from a file by
user [arg2].
Explanation: This message is for the use case where a
user restores a Management Controller configuration
from a file.
May also be shown as 4000001b00000000 or
0x4000001b00000000
Severity: Info
Alert Category: none
Serviceable: No
CIM Information: Prefix: IMM and ID: 0027
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is
required.
4000001c-00000000 Watchdog [arg1] Screen Capture
Occurred .
Explanation: This message is for the use case where
an operating system error has occurred and the screen
was captured.
May also be shown as 4000001c00000000 or
0x4000001c00000000
Severity: Info
Alert Category: System - other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0028
SNMP Trap ID: 22
Automatically notify Support: No
User response: If there was no operating-system error,
complete the following steps until the problem is
solved:
1. Reconfigure the watchdog timer to a higher value.
2. Make sure that the IMM Ethernet-over-USB
interface is enabled.
3. Reinstall the RNDIS or cdc_ether device driver for
the operating system.
4. Disable the watchdog.
If there was an operating-system error, check the
integrity of the installed operating system.
336
System x3550 M4 Type 7914: Installation and Service Guide
4000001d-00000000 Watchdog [arg1] Failed to
Capture Screen.
Explanation: This message is for the use case where
an operating system error has occurred and the screen
capture failed.
May also be shown as 4000001d00000000 or
0x4000001d00000000
Severity: Error
Alert Category: System - other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0029
SNMP Trap ID: 22
Automatically notify Support: No
User response: Complete the following steps until the
problem is solved:
1. Reconfigure the watchdog timer to a higher value.
2. Make sure that the IMM Ethernet over USB
interface is enabled.
3. Reinstall the RNDIS or cdc_ether device driver for
the operating system.
4. Disable the watchdog. Check the integrity of the
installed operating system.
5. Update the IMM firmware. Important: Some cluster
solutions require specific code levels or coordinated
code updates. If the device is part of a cluster
solution, verify that the latest level of code is
supported for the cluster solution before you update
the code.
4000001e-00000000 Running the backup
Management Controller [arg1] main
application.
Explanation: This message is for the use case where a
Management Controller has resorted to running the
backup main application.
May also be shown as 4000001e00000000 or
0x4000001e00000000
Severity: Warning
Alert Category: System - other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0030
SNMP Trap ID: 22
Automatically notify Support: No
User response: Update the IMM firmware. Important:
Some cluster solutions require specific code levels or
coordinated code updates. If the device is part of a
cluster solution, verify that the latest level of code is
supported for the cluster solution before you update
the code.